Take the back breaking work out of rolling up barbed wire. Save time and labor, rolls ¼ mile of wire in 4-7 minutes. Mounts to your post hole digger-skid steer mounted or three point. Easy to use one man operation.
-Unclip fence and drop wires on the ground.
-Push dead man shaft into ground to stabilize the post hole digger.
-Wrap wire around Wire Dawg and tie wire to wire. ( NOT to wire winder)
– Engage winder at idle speed and gradually increase speed after there are a few wraps of wire on wire winder.
-Lean the Wire Dawg back and forth slightly to evenly wind wire up and down on Wire Dawg.
-When end of wire is in sight, decrease speed and stop machine. Finish by securing ends of wire to wire ball.
-To remove wire bale, unlock and release cam, wire will simply drop off.
Flat steel is ¼” and laser cut, round stock made of DOM material. Deadman pin is 1” solid steel. ½” Grade 8 bolts. Wire Dawg is powder coated orange for high visibility. Wire Dawg weighs under 70 lbs.
Use the Wire Dawg to roll up multiple wires to be disposed of.
-Unclip fence and drop wires on the ground.
-Push dead man shaft into ground to stabilize the post hole digger.
-Wrap wire around Wire Dawg and tie wire to wire. ( NOT to wire winder)
– Engage winder at idle speed and gradually increase speed after there are a few wraps of wire on wire winder.
-Lean the Wire Dawg back and forth slightly to evenly wind wire up and down on Wire Dawg.
-When end of wire is in sight, decrease speed and stop machine. Finish by securing ends of wire to wire ball.
-To remove wire bale, unlock and release cam, wire will simply drop off.
Flat steel is ¼” and laser cut, round stock made of DOM material. Deadman pin is 1” solid steel. ½” Grade 8 bolts. Wire Dawg is powder coated orange for high visibility. Wire Dawg weighs under 70 lbs.
Use the Wire Dawg to roll up multiple wires to be disposed of.